Skip to content

make_hel_fils.m

Basic Information

  SYNTAX:  [fils,frac,Paths,fracp] = make_hel_fils(polpts,mmode,nmode, ...
                Rref,phase,iplot)

  PURPOSE:
    Construct helical filament sets for nonaxisymmetric mode on continuous
    surface such as plasma or vessel wall.

  INPUTS:
    polpts = set of poloidal points = (npts,2) matrix [x,z] [m]
    mmode = m poloidal mode number
    nmode = n toroidal mode number
    Rref = reference major radius [m]
    phase = (optional) phase relative to toroidal angle phi=0;
        phase=0 (default) gives cos mode, phase=-pi/2 gives sin mode.
    iplot = (optional) flag to select plotting: 0=no plot(default), 1= plot
   helicity = (optional) +1 for LH (default), -1 for RH

  OUTPUTS:
    fils = matrix describing set of filaments in [x1,y1,z1,x2,y2,z2] format
    frac = fraction of current in each filament (const on each hel winding)
    Paths = cell array of filament sets corr to each *path* in hel windings
        (note that the Paths cell array is a *column* cell array,
        dims {npaths,1} to allow row dimension to be used for modes...)
        NOTE WELL that the Paths matrices are in FILC format!!!
    fracp = vector of fracs corr to each *path*

  RESTRICTIONS:
    # of pts in polpts must be even multiple of mmode, and should be >> 1
    (for example for 3,1 mode must have multiple of 3, like 24, 36, 60...
     Multiples of 12 are nice, since contain factors 2,3,4)

  METHOD:

Dependencies