mut_rec2rec.m
SYNTAX: mut = mut_rec2rec(zphis,thetas,rs,tilts,dzphis,hs, ...
Rref,nfils,iplot)
PURPOSE: Calculate mutuals between 2 rectangular picture frame coils
in cylindrical or toroidal geometry (with straight legs parallel
to axial or toroidal direction respectively but not necessarily
at same minor or major radius).
INPUTS: (vectors are all 1x2)
zphis = vector of z (axial) (OR phi=toroidal angle) positions of frame
*centers*. If Rref=0, zphis specifies z positions. If Rref=1,
zphis specifies phi toroidal angles. [m if z, rad if phi]
thetas = vector of theta (angular) positions of frame centers [rad]
(absolute cylindrical angle if Rref=0, or poloidal angle
relative to the major axis of the torus at R=Rref for Rref~=0)
rs = vector of r (minor radial) positions of frame centers for Rref=0,
or R (major radial) positions of frame centers for Rref~=0 [m]
tilts = angle made by normal vector to picture frame (generated by
right hand rule from coil current) rel to minor radius if
Rref=0, or relative to major radius R if Rref~=0 [rad]
(If Rref=0, when coil frame is tangent to cyl the tilt = 0)
(If Rref~=0, when coil frame is *vertical* the tilt = 0)
dzphis = vector of full widths of frames (linear width in [m] for Rref=0
and angular width dphi in [rad] for Rref~=0)
hs = vector of full heights of frames [m]
Rref = (opt) Reference major radius for toroidal case AND flag to specify
whether cylindrical (=0, default) or toroidal (NOT =0) (units
of [m] in toroidal case, and used only as flag in cylindrical)
(def = 0)
nfils = (opt) vec of # of sub-filaments to split legs into (def=10)
iplot = (opt) if =1, plot 3D geometry (def=0)
OUTPUTS:
mut = mutual inductance [uH]
RESTRICTIONS:
Presently set up for only 2 coils...
METHOD:
Uses Jim Leuer's mut_fil_fil.m (3d filamentary segment to filamentary
segment mutual calculator). For cylindrical geometry, r,theta plane in
this code correspond to x,y plane in mut_fil_fil, and z = z (axial
direction of cylinder). For toroidal geometry, r,phi in this code
correspond to x,y plane in mut_fil_fil (which is the plane defined by
major radius and toroidal angle phi in torus), and theta is poloidal
angle in tokamak convention. The z direction is thus the same as the
usual convention for tokamak geometry: poloidal, or "vertical" z.
Rref is used as ref major radius of torus for applying poloidal angles.
Dependencies