Skip to content

chirpmulti_fresp.m

Basic Information

 SYNTAX: [gain,phi,freq] = chirpmulti_fresp(input_d,input_t,
    output_d,output_t,min_freq, max_freq, in_yaxis, out_yaxis,
    inpowerof2, out_powerof2, npeaks, showplots)

  PURPOSE:  multidimensional version of inout_fresp.m for chirp wave
  signal input.  Modified from same type of algorithm for sine wave inputs.
  Not very successful in getting good data from chirp wave inputs because
  of S/N problems, so results should be viewed with suspicion.

  INPUT:
    input_d = input data vector
    input_t = input time vector
    output_d = output data vector
    output_t = output time vector
    min_freq = minimum frequency - don't look at spectrum below this
    max_freq = maximum frequency - don't look at spectrum above this
    in_yaxis = vector of ymin and ymax values for input data plots(optional)
    out_yaxis=vector of ymin and ymax values for output data plots(optional)
    powerof2 = integer = some power of 2 greater than the number of samples
        in either input_d or output_d, to use in fft (optional)
        signal is zero filled to this number. (this speeds up fft
        calculation as well as giving finer frequency sampling for
        more accurate gain/phase calculation)
    npeaks  = number of points (peaks) in spectrum at which to compute resp.
    showplots= set=1 if you want to see plots, otherwise no plots (optional)

  OUTPUT:
    gain   = calculated gain from input to output signal
    phi  = calculated phase from input to output signal (degrees)
    freq   = calculated frequency of input signal (output is checked also)

  RESTRICTIONS:
    (1) Both input and output data MUST have uniform sampling rate.
       (2) Both input and output data MUST represent same time window.

Dependencies