Skip to content

plot_simulink_shapes.m

Basic Information

  SYNTAX: plot_simulink_shapes

  PURPOSE:  Plot results of SIMULINK simulations which use the S-file
        sim_Xpt2.c in an EFIT type contour plot.

  INPUT:
    algorithm = one of 'isosnull', 'isousnull', or 'isodnull'
    filename = g0 file containing equilibrium around which plant
            model was created
    tstart = first time to plot simulated boundary (seconds), default 0.0
    stepsize = steps for boundary plots (seconds), default 0.01s
    plot_geometry = set to 1 to plot D3d geometry around equil. (default 0)
    axis_to_show = plot range to show = argument to axis function
            (optional, default = [1 2.3 -1.4 1.4]
    figure_num
   (generated by simulink simulation and its setup process):
    time_sim0 = output of simulink model
    nsegments
    Xpt_sim
    tgt_sim
    simXpt2_flux_sim

  OUTPUT:
    plot - Steps through multiple time slices:
        - shows yellow x on control segments where flux = Xpt flux
        - connects yellow line between these x's and to Xpt.
        - shows yellow * for location of magnetic axis (location is
          updated for z coordinate, r coordinate is assumed fixed)
        - shows target points with red +
        - original equilibrium shown in white (with mag axis = x)
    figure_num

  RESTRICTIONS:
    (1) requires g0* file exist

  METHOD:  The flux on each control segment at time t is approximated
    by adding the flux on the segment at equilibrium to the change in flux
    of the chosen control point (on that segment) from equilibrium.
    Then the point on the segment whose flux is closest to the Xpt flux value
    at time t is used to define the boundary location at time t.

Dependencies