Skip to content

read_gfile.m

Basic Information

  USAGE:  >>read_gfile

  PURPOSE: Script to read efit ASCII g-eqdsk file w/ flag iecurr=2 set

  INPUTS: [default]
     filename = ['g083750.04838'];  g0-eqdsk filename - Can contain directory
     nfcoil = [18];  # of F-coils; must be specified for non-D3D (Optional)
             defaults to D3D values of nfcoil=18
     nesum =  [6];   # of E-coils; must be specified for non-D3D (Optional)
             defaults to D3D value of nesum=6 (for > 6seg case)
     old_efit=[0];   For iecurr=2 several different flavors of efit output
                        exists. (Optional) For old versions of efit (i.e. NSTX)
                        you want old_efit=1 since they use older efit version.

  OUTPUTS:
   (Produces large set of data objects from g0-file in Matlab environment.)
    ireadok = flag to report good read of gfile (0=bad, 1=good)
    jphi=current density on grid  MA/m^2
    psizr = true total flux on grid in Wb
    psimag = axis flux in true Wb
    psibnd = boundary flux in true Wb  (psibry also defined same)
    cc = E/F coil currents in MA-turns
    cc2 = E/F coil currents in MA-turns (for 2-segment E-coil)
          CAUTION: cc2 has min(2,nesum) E-coil elements (could be 1 vs std: 2)


  RESTRICTIONS:
     g0 file must be produced by EFIT run with flag iecurr=2 in order to
      write current density distribution on grid.
   Must set nesum to correct number of e-coil segments at top of file.
   May overwrite some data objects in D3D environment from load_d3denv.

  METHOD:
  Follows write/read format of EFIT file weqdskx.for, reads usual g-file data,
      reads coil current and jphi data (if iecurr was set =2 in EFIT run),
      defines some flux variables and converts some variables to D3D Matlab
      data environment standards.

Dependencies