Skip to content

mutind_fine.m

Basic Information

  SYNTAX: mutuals=mutind_fine(acoil_data,bcoil_data, ...
                    nrecta,nrectb,verbose)

  PURPOSE:  Compute mutual inductance between 2 sets of axisymmetric
    conductors, each of whose cross-section is a parallelogram.  Filament
    conductors (identified by setting dR=dZ=0 in bcoil_data) are allowed
    for conductor set B.

  INPUT:
    acoil_data = data describing geometry of coil set A
    bcoil_data = data describing geometry of coil set B
       Format of this data has each column = [Z;R;dZ;dR;AC;AC2], where:
        Z   = z centroids of conductors (m)
        R   = r centroids of conductors (m)
        dZ  = height of conductors (m)
        dR  = width of conductors (m)
        AC  = angle between coil and horizontal (degrees)
        AC2 = angle between coil and horizontal (degrees)
    At most one of AC, AC2 is nonzero and indicates type of parallelogram:
                                xxxx
                            xxxx   x
                        xxxx       x
                    xxxx           x       ---                 xxxxxxxxxxxxx
                xxxx               x        |                xx         xx
       ---  xxxx                   x        |              xx         xx
        |   x          X        xxxx      dZ             xx         xx
        |   x        (R,Z)  xxxx            |          xx   X     xx
      dZ    x           xxxx                |        xx   (R,Z) xx
        |   x       xxxx                    |      xx         xx
        |   x   xxxx                        |     xx         xx
       _|_  xxxx   ^                       --- xxxxxxxxxxxxx    ^
                 AC )                                        AC2  )
            |----------dR----------|           |---dR------|

    nrecta = rectangle partitioning for conductor set A (see header
        documentation for bld_subelements.m)
    nrectb = rectangle partitioning for conductor set B (see header
        documentation for bld_subelements.m)
       verbose = print/display verbose info.  0 = no print/display.  Numbers>0
               give increasingly more information/displays.

  OUTPUT:
    mutuals = mutual inductance matrix, with rows corresponding to coil
        set A, columns to coil set B (micro-Henries)

  RESTRICTIONS:

  METHOD:  Each conductor is partitioned into a bunch of tiny rectangles.  All
    mutuals are computed for these rectangles, then combined at the end.
    Mutuals calculation is done in 2 steps:
    (1) use filament to filament calculation for all subelements
    (2) replace those subelement calculations which would have inaccurate
    results, based on geometric information, with more accurate calculation.

Dependencies