Skip to content

make_wallmesh.m

Basic Information

  SYNTAX:  [vvPfils,vvTfils,Cvpol,Cvtor] = make_wallmesh(vvpolpts,torangs, ...
                                            iclosepol,iclosetor,iplot,Rref);

  PURPOSE:  Generate filament array for mesh representation of toroidal
  wall or wall segment.

  INPUTS:
   vvpolpts = array of poloidal points for wall representation (npts,2)
               [R(:) Z(:)]  [m]
   torangs = toroidal angles for wall discretization [deg]
   iclosepol = flag =1 to select closing of wall in pol direction (def=1)
   iclosetor = flag =1 to select closing of wall in tor direction (def=1)
   iplot = flag to select plotting if 3D geometry

  OUTPUTS:
   vvPfils = filament array for poloidal-pointing filaments in mesh representation
   vvTfils = filament array for toroidal-pointing filaments in mesh representation
   Cvpol = constraint matrix for poloidal filaments (total constraint
           matrix is Cvv=[Cvpol Cvtor], total filament matrix is
           vvfils = [vvPfils; vvTfils])
   Cvtor = constraint matrix for toroidal filaments

  RESTRICTIONS:

  METHOD:
   Two filament arrays are produced, one for poloidally-pointing filaments
   and one for toroidally-pointing filaments. Poloidal and toroidal
   filaments with the same index emerge from the same point. Filaments associated
   with a given point are the right-pointing toroidal and the upward-pointing
   poloidal filament.
   Constraint matrix represents the node current equations: # of rows = total # of pts
   (=npolpts*ntorpts), while # of columns = # of pol fils + # of tor fils
   = 2x(tot # of pts). Constraint equation is thus C*I=0, so current vectors lie in
   null space of constraint matrix.

Dependencies