Skip to content

ohmic_dist1.m

Basic Information

  USAGE: [ohmic_dist_data] = ohmic_dist1(ohmic_calc_inputs)

  PURPOSE: Calculates the Best Ohmic current distribution for F coils

  INPUTS: [default]
    ohmic_calc_inputs = structure, containing one or more of following:
     cccirc   = coil connection vector
     Pcc      = mapping from coil states to all PF coils
                (only one of cccirc or Pcc should be provided)
     pfcoils_oh = indices of PF coil to use in ohmic distribution
     flux0    = target flux at center, scaler (Vs) [1]
     bz_targ  = target vertical field scaler or (npt,1) (T) [0]
     ic_min   = minimum coil currents (A), either full set or current states
     ic_max   = maximum coil currents (A), either full set or current states
     vacuum_objs = vacuum model objects for the device
     npt      = Number of points on boundary for optimization [101]
     r_plasma = Major radius of breakdown circle (m)
     z_plasma = Z Location of center of breakdown circle (m) [0]
     rpt, zpt = R,Z Plasma boundary Points (m) (alternatively, use a,k,d below)
     a_plasma = Minor radius of breakdown circle (only needed if no rpt,zpt)
     k_plasma = Elongation of breakdown circle (only needed if no rpt,zpt)  [1]
     d_plasma = Triangularity of breakdown circle(only needed if no rpt,zpt)[0]
     minimize_i = 0.1;  Includes currents in opts. to reduce +-I [0]
                  minimize_i weights how much I smooting to perform
                  Value of 0 to 0.1 are reasonable
     pause_it=   1; => pause between figures [0];
     figure_num = optional, if not provided then no plotting

  OUTPUTS:
   ohmic_dist_data = structure, containing:
     ic_ohmic =   Optimum Ohmic Terminal Current vector  (A)
     ict_ohmic=   Optimum Ohmic Amp-Turn Current vector  (A-Turns)
     fl       =   Flux on Boundary (Vs)
     br       =   Br-field on Boundary (T)
     bz       =   Bz-field on Boundary (T)
     rpt zpt  =   R,Z boundary points used in analysis (m)
     err      =   Average Error in booundary flux value (Delta_Vs/Vs)
     figure_num = updated figure number (if figure_num is input)

  Plots:
     figure(1): geometry -- Flux contour -- cccirc numbering -- coil current
     figure(2): geometry -- B-field contour -- A-turn for full coil system
     figure(3): flux variation around circumference of breakdown circle
     figure(4): B-field variation around circumference of breakdown circle

  RESTRICTIONS:

  METHOD:
     Determine optimum Coil current distribution using least square technique
     to produce a uniform 1 Vs flux on the boundary see ohmic_dist.m
     now very similar to CUROPT by including Bz and constraints on currents
     now calculates based on terminal currents rather than (amp-turns)

Dependencies