Skip to content

correct_drift.m

Basic Information

  SYNTAX: corrected_d = correct_drift(old_data, old_tvec, nsamples, sampleloc)

  PURPOSE:  Correct measured shot data for integrator drift.

  INPUT:
    old_data = data vector to correct for drift
    old_tvec = time vector corresponding to old_data
    nsamples = optional number of samples to use to calculate
               average offset at beginning and end (default 25)
    sampleloc= optional location of "end" (1st, last) set of samples for
        defining the average offset at "end" (default is last sample
        of vector) if not specified, or specified as a number <0,
        default=data length

  OUTPUT:
    corrected_d = data corrected for drift

  RESTRICTIONS:
     (1) Assumes approximately linear drift over duration of shot.
     (2) MUST HAVE >=28 samples both at beginning and end of shot from which
      to calculate beginning and end offsets (UNLESS nsamples < 25).

  METHOD: Samples are averaged at beginning and end of data to define beginning
    and end offsets.  Beginning offset is subtracted out.  A linear drift
    defined by the 2 offsets is assumed and corrected for in remainder of data.

  SEE ALSO: correct_drift_intvals

Dependencies