Skip to content

inout_fresp.m

Basic Information

  SYNTAX: fresp = inout_fresp(fresp_inputs)

  PURPOSE:   Calculate frequency response for a generic input/output pair of
 sinusoidal signals.  DC components of both signals are removed
 before calculating response.

  INPUT:
   fresp_inputs = structure containing:
    out_num = output number for output_d (use 1 if only one output)
    input_d = input data vector
    input_t = input time vector
    output_d = output data vector or matrix (i.e., one output per column)
    output_t = output time vector
    max_search_f = maximum frequency - don't look for spectral peaks past this
    max_plot_f  = maximum frequency in plot of spectra of input/output signals
   And optionally:
    powerof2 = integer = some power of 2 greater than the number of samples
        in either input_d or output_d, to use in fft (optional)
        signal is zero filled to this number. (this speeds up fft
        calculation as well as giving finer frequency sampling for
        more accurate gain/phase calculation)
    showplots= set>=1 to see plots used in freq response calculation, otherwise
        0 (default), use a value > 1 to cause program to wait after each plot
    reject_thresh = thresholds for declaring response = NaN when problems with data, e.g.
        input/output frequencies don't match, or SNR of output too small
        = [freq_thresh (), snr_thresh (dB)] (default = 10, 0 dB)
    verbose = set > 0 to get printed diagnostic information (larger numbers => more info)

  OUTPUT:
   fresp = structure containing:
    gain   = calculated gain from input to output signal
    phi  = calculated phase from input to output signal (degrees)
    freq   = calculated frequency of input signal (output is checked also)
    max_in = maximum amplitude of input signal
    max_out= maximum amplitude of output signal

  RESTRICTIONS:
    (1) Both input and output data MUST have uniform sampling rate.
       (2) Both input and output data MUST represent same time window.

Dependencies