Skip to content

MREfun.m

Basic Information

  USAGE: dwdt = MREfun(eq2d,w,j_eccd,fwhm_eccd,misalignment,toroidal_angle)

  PURPOSE: Calculate dw/dt from Modified Rutherford Equation

  INPUTS:  eq2d, structure with 2-D equilibrium inputs:
                 q,            safety factor at NTM-resonant surface (e.g. 2/1 or 3/2)
                 dqdR,         dq/dR at q-surface
                 delta_prime0, delta_prime at q-surface before ECCD is applied
                 tau_R,        resistive time at q-surface [sec]
                 j_tot,        total current density at q-surface
                 j_boot,       bootstrap current density at q-surface
                 wmarg,        marginal island size (2*ion banana width)
                 Rqmin,        minimum major radius of q-surface
                 Rqmax,        maximum major radius of q-surface

           w,             full width of NTM
           j_eccd,        peak ECCD density (Gaussian profile)
           fwhm_eccd,     Full Width at Half Maximum of ECCD
           misalignment,  offset between ECCD peak and q-surface (default 0)

           toroidal_angle, toroidal angle where ECCD is deposited from 0=O to 180=X,
             if omitted an average dw/dt is calculated for continuous ECCD on rotating NTM
             if == 'O' then O-point modulation with 50 duty cycle is used
             if == 'X' then X-point modulation with 50 duty cycle is used

          j_tot, j_boot, j_eccd must all be same units (j_tot=1 is an example)
          All lengths including 1/delta_prime0 and 1/dqdR in same units [m]

          Inputs can be any mix of *one* size [n1,n2] and size [1,1]
          eq2d must be size [1,1] but its fields can be size [n1,n2] or [1,1]

  OUTPUTS: dw/dt, rate of change of island width [m/s]

  METHOD: MRE from Nucl Fusion 49, (2009) 045005, Prospects for..

Dependencies